heavy duty ironing board cover_drawstring ironing board cover

When a seal is angularly misaligned – or cocked on the shaft – an irreversible process begins. Excessive pressure on one section of the seal, when not installed properly, can cause the spring to become dislodged or the seal to heat up and become brittle through excessive wear, both leading to a premature failure.

In situations where the shaft has splines or an integral gear on the end, you’ll want to take precautions. These gears and splines often have very sharp edges that are quite detrimental to the seal’s integrity. You may use an installation sleeve that will allow the seal to slide past these hazards undamaged.