ironing board cover 36 x 12_tablecloth with parasol hole

a) The shaft on which the oil seal is to be mounted should be ground with the surface finish or surface roughness between 0.2 to 0.8 Microns. It is best for the shaft to be hardened atleast to 40 – 45 HRc in order to prevent groove formation on the shaft due to the pressure exerted by the spring.

The numbers 30-50-10 indicate the dimensions of the oil seal, specifically its inner diameter, outer diameter, and height. This measurement ensures that the oil seal fits perfectly into the designated space and effectively seals off any potential leaks.

Usually, these oil seals are used to seal lubricating oil or grease and contain it within the application, so that moving parts such as bearings are continually supplied with enough lubrication. However, such seals are also used for sealing other liquids, gases, and solids, such as powders or granules.

We just discovered that one of the seals on our pumping system is leaking. Do you have any ideas as to what could have caused this, and can you offer some advice for selecting a good seal?