small ironing board cover and pad_soccer tablecloth

ERIKS type R (type A according to the DIN standard) is identical in shape to type M, but has a rubber outer case with metal reinforcement on the inside. The rubber creates a good seal in the housing, even if the housing has suffered minor damage or is not in its best condition for other reasons. The RST version has a dust lip. These types are often chosen to replace a type with a metal outer case because they are easier to install and can cope with minor damage to the groove, such as scratches.

Leather is probably the oldest of the lip materials still in common use, but the move towards mass production methods has seen a massive increase in the development of synthetic rubbers which lend themselves to accurate and repeatable injection and compression moulding. Nitrile (NBR) is still by far the most common elastomer for “normal” use, whilst Viton® (FKM/FPM) is rapidly replacing Polyacrylate (ACM) and Silicone (VMQ) for high-temperature applications. Viton® also has high resistance to abrasion and chemical attack making it a preferred elastomer. Recent developments in the use of PTFE for Rotary shaft seals has caused widespread interest particularly for high-speed shaft rotation or poor lubrication applications.

The major cause of extrusion and nibbling is stress caused by high pressure. This is commonly noticed when the oil seal has a chipped or nibbled look. In fact, in some cases, the surface of the seal tends to peel on its own, which makes it have a shaved look. What the stress does is that it increases the clearance gap between the mating edges, which causes the seal to get entrapped, and then leads to severe physical damage.

Of course, all rubber materials and seals will provide a range of benefits; however, you will need to consider chemical compatibility, sufficient temperature ranges, pressure ranges, and more. 

Table 5: The major special seals, their shapes, and their features