leopard ironing board cover_λευκά τραπεζομάντηλα χύμα

Polyacrylate 
Better heat, oil and chemical resistance than NBR 
It is recommended for use in oil which contains load bearing additives such as EP gear oils

All are fitted with a spring to preload the sealing lip. All these types are for non-pressurised or low-pressure applications up to 0.5 bar for diameters of a limited size. For diameter of 500 mm or more, the maximum pressure is 0.1 bar. For higher pressures, special types or PTFE lip seals can be used.

When a seal is angularly misaligned – or cocked on the shaft – an irreversible process begins. Excessive pressure on one section of the seal, when not installed properly, can cause the spring to become dislodged or the seal to heat up and become brittle through excessive wear, both leading to a premature failure.