black and white ironing board cover_silver table cover

The seal shown in Fig. 14.2 is a relatively simple design; most automotive seals are more complex. Dust lips are often used to keep outside contaminants away from the oil lip seals; such seals thus have undercuts that make demolding more difficult. Fluoroelastomer compounds used for such undercut shapes must have reasonably high elongation at break at molding temperatures to avoid tearing the part during demolding. The metal insert is often U-shaped, and stock may be molded to form a thin layer over the outside of the insert. Since both compression and injection molding methods are used, suppliers of fluoroelastomers for shaft-seal applications often must provide different versions of the same polymer composition-medium to high viscosity for compression molding, and low to medium viscosity for injection molding. Different precompounds may be necessary to accommodate relatively long compression-molding times at low temperature and very short injection-molding times at high temperature.

Nitrile is the most widely used rubber (elastomer) and it’s recommended as the best for almost all standard applications. This is solely due to the fact that nitrile has some intrinsic properties, such as low cost and compatibility with most environments. Some of the general applications of nitrile are non-latex gloves, automotive transmission belts, footwear, gaskets, synthetic leather, hoses, o-rings, and oil seals.

VMQ (silicone)