ironing board cover 97 x 34_table top plastic cover

Runout must be kept to a minimum. Movement of the center of rotation is usually caused by bearing wobble or shaft whip. When coupled with misalignment, this problem is compounded. Contrary to popular belief and common practice, the installation of flexible couplings cannot correct or compensate for misalignment.

The durometer of an oil seal is typically dependent on the material it is made with. Common oil seal materials along with their durometers are as follows:

Figure 5 explains the JTEKT seal numbering system.
Seal numbers consist of
　(1) the seal type code,
　(2) the spring code,
　(3) the lip type code,
　(4) the dimensional numbers, and
　(5) the special type code,
and Table 6 shows examples of each of these codes/numbers.

DIN